Installation of the washer
Remove package
Installation of the bottom board
Installation of drain hose
!
Remove package and take out the bottom board of
the cabinet on the foam cover.
!
Open the washer's lid and take out accessories.
!
Remove the convex plastic block placed at the
center of foamed plastic cushion of the packing case.
this is for fixing the washer during shipment rather than a part of washer.
!
A trial operation or washing with foamed cushion base is strictly forbidden.
!
Tilt the back of washer forward slightly, push bottom board along
the base insertion grooves from the back of washer until it is
completely in place.
!
Fix the bottom board on the base of washer with screws.( There
is a small hole in rear side of bottom board ).
Convex plastic block
Base foamed cushion
!
Completely seat the drain hose over the
drain connector. Installation of water
inlet hose.
!
Fix and tighten it with a hoop. ( As shown
in the figure, and you can use a pliers to
finish it.)
Installation of water inlet pipe
Put the water
inlet pipe(which
has metallic
filtering bag)
screw on to the
tap.
Note: Use only the new supplied water
hose with your new appliance do not
use a hose from your existing machine
or a hose that has been used previously.
