Deter
gent etc
Maintenance of washer
Please keep the washer with neat appearance and perform correct maintenance to prolong the
service life of washer.
Cleaning of water inlet pipe joints
Unscrew and remove the water inlet pipe joint
from the washer and clean the filtering screen
of inlet valve with brush.
No
washing
Abnormal
draining
Abnormal
spin
Identifying common troubles of washer
List of faults and inspection
Faults
Inspection Items to be checked
No water
flows in
!
If the power is off or the fuse is burned out.
!
If the water supply is cut off or the water pressure is too low.
!
If the inlet hose is properly connected and the water tap is opened.
!
If the filtering screen of inlet valve is blocked by dirt.
!
If the coil of inlet valve is damaged. (The slight electromagnetic
sound is normal phenomenon when the inlet valve is switched on)
!
If the "Start / Pause" button is pressed after the power
switch is pressed.
!
If the power is off or the fuse is burned out.
!
If the power supply voltage is too low.
!
If the water amount reaches to the required water level.
(The washer will not work until the water amount does not reach the
required water level)
!
If the water drain hose has been very high..
!
If the end of water drain hose is sealed in pond.
!
If the internal rubber seal ring of drain valve is blocked by dirt.
!
If the door lid is closed.
!
If all clothing piled largely at one side of barrel or the clothing
is excessively placed.
!
If the washer is not placed in stable condition or it is placed in
inclination state. (The ground is not flat).
!
If the motor belt is loosened.
Note:
During the spin process, if washings are piled at one side of the spin barrel, it will cause unbalance of spin barrel resulting in
striking. At this moment, the computer inside the washer will feel this unbalance phenomenon and will automatically
correct it ( fill in water Washing ). However, if unbalance situation is not removed after continuous three corrections, the time
buzzer start to alarm, which means the computer auto-correction can not resolve the problem. Then the user has to manually
and evenly place the clothing inside the barrel to solve the problem.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
