Trico FM-6, Руководство пользователя, Страница: 5 / 36

Page 5 of 36
2. Packing List and Assembly
The purpose of this section is to aid the user with the initial assembly procedures required when the FM-6
is first taken out of the shipping container. There are only a few steps that must be carried out.
The FM-6 is shipped in a single box which contains the following items:
1 – FM-6 unit 1 – O-ring Kits 1 – USB Mouse
1 – User Manual 2 – Vial Clips 1 – Waste Bottle
1 – Universal AC cord 1 – Fuse 1 – Luer Lock Syringe
1 – Fixer Priming Bulb
2.1 – FM-6 UNIT ASSEMBLY
To assemble the parts, follow these instructions:
1. Carefully remove the FM-6 unit from the box and place it on a hard level work surface or table to
support a load greater than 27 lbs (12 kg).
2.
Locate the nameplate on the back panel. Record the serial number on the cover of the User
Manual for future reference.
3. Unpack the waste bottle and place the bottle into the waste bay by pressing the top right portion
of the door inward and allowing the door to open. Gently pull the waste cap from the bay and
thread the bottle onto the cap and tighten. Push the hose coming from the top of the waste bay
back into the unit and place the bottle into the cradle. Then close the waste bay door.
4.
Place the fixer bottle into the fixer bay located on the right side of the FM-6 by tipping the bottle
and placing the tubing into the neck. Then position the bottle with the label facing outward into
the fixer bay.
NOTE: Not facing the label outward blocks the sensors and will give false indications.
5. Locate the universal AC cord and place the female IEC plug into the male socket on the FM-6.
6.
On the bottom right side there is the sample pump vent barb, a 1/8” diameter line can be
connected to the barb and run to a vent hood if necessary to vent fumes.
7. Ensure the support feet under the waste and fixer bay are adjusted in the up position.
8.
Place the male plug end into appropriate AC electrical outlet.