- 4 -
20. Position the beam horizontally.
21. Remove the cap plugs (2) from the beam. (Fig. 3)
22. Use a 9/16 in. socket to loosen the drive belt tension
nuts (2) just until belt tension is released. (Fig. 1)
23. Remove the 1/4 in. (10) and 5/16 in. (2) beam
screws. (Fig. 3) The outside beam should remain in
place, supported by dowel pins.
24. Carefully remove the outside beam assembly,
making sure to keep the tension slide assembly
attached to the inside beam. The drive belt is also
disengaged at this time.
25. Rotate the track knob until the tension bushing can
just be removed from the tension slide assembly.
26. Remove the tension slide assembly by lifting the
tension shaft off of the take-up shaft assy. and out,
in order to disengage the slide from the track stud.
27. Remove the take-up shaft assembly.
28. Remove the track stud from the track knob. (Fig.1)
29. Remove the retaining ring from the track knob.
30. Remove the track knob & washer.
31. Remove the wheel lock assy. (special tool required)
32. Remove the drive belt tension nuts (2), lock
washers (2), and flat washers (2).
33. Remove the inside beam from the motor pivot.
34. Remove the pivot lock screw, lock washer, and flat
washer.
35. Remove the pivot drag screw, lock washer, and flat
washer.
36. Remove the motor pivot from the motor.
37. Remove the set screws (2) from the motor sheave.
