- 9 -
33. Install the tension knob and tighten (holding the
knob with a strap wrench) by turning the bushing
counter-clockwise with a 3/8 in. allen wrench.
34. Install the tension knob screw and tighten (holding
the knob with a strap wrench) by turning the screw
clockwise with a 5/16 in. allen wrench.
35. Attach the take-up lever (with seal) to the take-up
shaft so that the lever is parallel with the long axis
of the beam (when in the “lock” position) and
tighten the screw.
36. Place the idler seal plate (with seal) and idler seal
spring onto the idler support.
37. Install the idler guard, making sure that the set
screws (2) align with the recesses in the idler
support for proper orientation and spacing.
38. Install the idler wheel screw through the idler
guard & into the idler support about 2 turns.
39. Install the platen mount to the beam leaving the
screws (4) slightly loose for platen adjustment.
40. Install the platen to the platen mount, leaving the 2
inside screws for later.
41. Install the idler wheel assembly and tighten the
idler wheel screw with a 3/16 in. allen wrench.
42. Install the workrest arm assy. onto the contact
support, making sure it is up against the shoulder.
43. Install the contact wheel, washer, and nut.
44. Using a straight-edge, align the platen with the
tangents of the center portions of the contact and
idler wheels and tighten the mount screws (4).
45. Install the remaining platen screws (2).
46. Install the belt guard standoffs (2) to the beam.
