Installation
18
- 18 -18
Manual channel search
In manual channel search, you can enter the channels to be searched directly.
In the
Installation
menu, move the cursor using the buttons
onto the line
Channel search
and press the
OK
button. The following menu will appear:
This is how to perform a manual channel search:
Select the line
Antenna
using
and
Terrestrial
using the ◄ or ► buttons.
Select the line
Search mode
using
and
Transponder
using the ◄ or ► buttons.
In the line
Encrypted,
select whether the channel search should also include encrypted
channels, using the ◄ or ► buttons.
No
= encrypted channels will be ignored.
Yes
= encrypted channels will be included in the search.
In the line
Frequency,
use the ◄ ► buttons to select the channel that should be searched.
Move the cursor onto the line
Start channel search
using the
buttons and start the search
process by pressing the OK button.
Now two windows are shown, listing the newly found TV and radio programmes.
The “Status”
window shows how far the search has progressed.
- Display:
Scanning
=> Search is active
- Display:
Complete
=> Search is finished.
You can leave this menu by pressing EXIT. If not finished, the channel search algorithm is
aborted. If new channels are found, you are asked to store them (Yes). Select your choice by
◄/► and confirm with OK. If selected YES the new channels are stored at the end of the
channel list now.
Network channel search (NIT search).
A network channels scan can be done the same way just choose “Search mode” = Network.
Installation
– Factory reset
This menu item allows you to reset the receiver to its default factory status. Afterwards the
receiver starts up with the Welcome Screen (initial installation) again.
Channel search
Antenna
Search mode
Encrypted
Modulation
Symbolrate
Channel
Cable
manually
No
QAM 64
6.900MS
7 (191.5MHz)
Start scan
