40
No part of this document may be reproduced, stored in retrieval system or transmitted by
any means, electronic, mechanical, photocopying, recording or otherwise, without written
permission from Tri-Star Technologies.
Enable Z-Axis
is for marking within a 3D object.
Laser Mode
specifies Scanboard signals that are used for laser controls.
Laser Period
determines remote Q-SW triggering frequency. Frequency is factory set up for
optimum laser performance. Altering the frequency may change laser performance and marking
pattern.
Pulse Width 1
determines the duty cycle of the triggering signal. Pulse width of 16ms for the
laser period of 33ms corresponds to the 50% duty cycle.
Pulse Width 2 is
only used for CO2 lasers.
Click the
Save
button to reinitialize the Scanner.
Click the
Cancel
button to close the window without saving. Detailed description of the
scanner parameters is given in Appendix C.
