Tri-Clover Tri-Flo CL Series, Руководство по обслуживанию и установке

Страница: 3 / 43

- 3 -
DO read and understand these instructions before installing or using the pump.
DO NOT modify the pump. Modifying the pump creates unsafe conditions and voids all
warranties.
DO use Tri-Clover spare parts when replacing a component of the pump.
DO NOT place the pump in an application where the service ratings are exceeded.
DO NOT service the pump while it is running.
SAFETY PRECAUTIONS WHEN INSTALLING PUMP
DO use an authorized electrician when connecting the pump.
DO observe the mechanical limits of the pump (refer to the pump performance sheet).
DO NOT lift the Motor and Pump by the pump casing or wingnuts.
If it is necessary to regulate flow out of the pump, DO install a throttling valve in the discharge
outlet line. DO NOT install a throttling valve in the suction inlet line.
SAFETY PRECAUTIONS WHEN OPERATING PUMP
DO NOT touch the pump or the lines when pumping hot fluids or when performing Clean In Place
(CIP) procedures.
DO NOT run the pump with BOTH the suction inlet and discharge outlet blocked. Running the
pump with the inlet blocked will cause serious damage to the pump.
DO NOT check pump rotation with liquid in the pump.
DO NOT run the pump with the impeller rotating in the wrong direction. Rotating the impeller in
the wrong direction may cause damage to the pump.
DO NOT operate the pump without the seal guard in place.
SAFETY PRECAUTIONS WHEN SERVICING PUMP
DO ensure the pump is cool to touch before performing service.
DO relieve all pressure and drain all fluids from pump and connected piping before performing
service.
DO ENSURE POWER TO THE UNIT HAS BEEN UNPLUGGED PRIOR TO PERFORMING ANY
PUMP MAINTENANCE OR CLEANING.
DO exercise caution and wear protective clothing when using lye or acid for cleaning.
These instructions contain operating and service information for the pump only. Motor
information is provided separately by the motor manufacturer.
SAFETY
DO'S AND DON'TS