TRENDnet TVP-221H, Руководство пользователя системного интегратора, Страница: 24 / 59

The CLI maintains three areas where the parameters are stored:
y
Temporary
y
Active
y
Non-volatile Storage (NVS)
When a set command is entered and processed, it changes the parameter value in
the Temporary area. This does not affect current operation of the TVP-224HR,
which is using the values in the Active area. The
config activate command moves
configuration data from the Temporary area to the Active area, where it can
actually be used. Thus a user can make multiple changes in the Temporary area
using
set commands, then put them into use with a single config activate
command. (Note that the config activate command may only be used between
calls, and will usually tear down any in-progress calls when invoked.)
Configuration data in the Active area is only available while the TVP-224HR
remains in operation. If the TVP-224HR is reset, the Active area is reloaded from
the data stored in NVS. Data in the Active area may be saved to NVS by entering
the
config store command.
For most of the H.323 parameter, settings won’t take effect until the TVP-224HR
reset. To ensure the H.323 setting to take effect, it is recommended to reset the
TVP-224HR after changing the settings using the
set command.
In summary:
y
Use set commands to make configuration parameters changes in the
Temporary area
y
Use the config activate command to move the new values into the Active
area, available for use
y
Use the config store command to save the new Active values in NVS
y
Reset the TVP-224HR after changing H.323 settings and storing the setting to
NVS.
22 config {activate|store|erase}
Use the activate command to manage the configuration data. A sequence of
set command is typically preceded by and/or followed by the config command
for the set command to become active.
Syntax description
activate Move the configuration from temporary area to active area.
store
Store the active configuration data into non-volatile storage.
erase Erase the configuration from non-volatile storage.
23 show h323
The show h323 command displays the settings of the parameter that are
related to H323 signaling protocol.
Syntax Description