TRENDnet TVP-221H, Руководство пользователя системного интегратора, Страница: 13 / 59

Command Line Interface
The TVP-224HR has a built-in command line interface and provides users a Command
Line Interface (CLI). You can configure TVP-224HR by entering commands from the CLI.
You can access the CLI from a VT-100 terminal or terminal emulator connected to the RS-
232 port on the front panel or through a Telnet session.
2.1 Connection through Serial Port
The serial port of the TVP-224HR is fixed at the following settings:
Baud rate 19,200
Number of data bit 8
Parity check None
Number of stop bit 1
Flow control None
To access the TVP-224HR through the RS-232 serial port, follow the steps below:
1. Insert one end of the serial cable that came with the TVP-224HR into the 9-
pin RS-232 port (labeled User Console) on the front panel.
2.
Insert the other end of the cable into your terminal’s serial port.
3.
Configure the terminal so that settings for baud rate, number of data bit, parity
check, number of stop bit and flow control capability exactly match TVP-
224HR’s serial interface. (Refer to you terminal documentation for more
information about setting up these features).
4. Press <Return> from the terminal.
5. When the empty HyperTerminal Screen appears type “123”
6. The TVP-224HR displays the following prompts on the terminal and you are
ready to access the CLI then.
Console>
Task Prompt Type
In the event that you forget your administration
password, you can gain console access to the
TVP-224HR using the super password. The super