TRENDnet TEG-448WS - Switch, Руководство пользователя, Страница: 9 / 34

9
Then, use screws provided with the equipment rack to mount each
switch in the rack.
Figure 3. Mount the Switch in the rack
Connecting Network Cable
The Switch supports 10/100/1000Mbps Ethernet that runs in Auto-
negotiation mode, 10/100Mbps Ethernet that runs in half and full
duplex mode and 1000Mbps Gigabit Ethernet that runs in full duplex
mode using four pair of Category 5 Cable.
These RJ-45 ports are Auto-MDIX, allowing you to use either a
standard or crossover RJ-45 cable.
There are 4 additional mini-GBIC slots for optional mini-GBIC
modules.
AC Power
The Switch uses 100-240V AC, 50-60 Hz AC power. The switch’s
power supply will adjust to the local power source automatically and
may be turned on without having any Ethernet cables connected.
10
IDENTIFYING EXTERNAL COMPONENTS
This chapter describes the front panel, rear panel, and LED indicators
of the Switch.
Front Panel
The figure below shows the front panel of the Switch.
Figure 4. Front panel of 48-port Gigabit Ethernet Switch
LED Indicator:
Comprehensive LED indicators display the status of the switch and
the network (see the LED Indicators chapter below).
1000BASE-T Gigabit Ethernet Ports (Port 1~48):
The Switch has 48 auto-negotiation, auto-MDIX Gigabit ports
.
These ports
can operate in half-duplex mode for 10/100Mbps and full-duplex mode for
10/100/1000Mbps.
Note: When the port is set to “Forced Mode”, the Auto-MDIX will
be disabled.
mini-GBIC Ports (Port 45F~48F)
The Switch is equipped with four mini-GBIC ports. The ports
support optional 1000BASE-SX/LX mini-GBIC module.
Port 45, 46, 47 and 48 are shared with the mini-GBIC 45F, 46F, 47F
and 48F ports. When you plug in a mini-GBIC module, the device the
RJ-45 port will be disabled.
Reset: