TRENDnet TEG-30102WS, Руководство пользователя, Страница: 17 / 109

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEG-30102WS
13
For new IPv4 address interface, enter the IP Address, and Subnet Mask to assign to the
VLAN and click Apply.
In the example, we will assign an IPv4 address of 192.168.50.200 and subnet mas of
255.255.255.0.
Under System > IPv4 > IP Address, you will see the updated IPv4 address interface
assigned to VLAN 50.
The VLAN with the assigned IPv4 address interface can now be used for IP routing
purposes. You can repeat the steps to create additional VLANs and assign other IPv4
address interfaces.
6. Click Save Settings to Flash (menu).
7. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Adding IPv4 Static ARP entries
System > IPv4 > ARP Settings
This section also allows you to create static ARP entries which may reduce some
network overhead by creating entries for hosts that will consistently communicate to
the switch in the current network environment. This will prevent the need for additional
ARP requests and replies over the network.
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on System, click IPv4, and click ARP Settings.
3. Review the settings for the static ARP configuration below and click Add to add the
static ARP entry to the ARP table.
Interface VLAN: Enter the VLAN ID that the static ARP entry will reside.
ARP IPv4 Address: Enter the IPv4 address for the static ARP entry.
Link Layer MAC Address: Enter the MAC address for the static ARP entry.
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.