4
IQ41x Installation Instructions - Configuring TG201251 Issue 5, 22-Aug-2014
IQ41x
InstallationInstructions-Configuring
14
SetupIPAddressingDetails
(if using Ethernet)
15
Set up Virtual CNC
(if required)
Use IP Tool – see step 13 – to choose either static (fixed) or
dynamic (DHCP) addressing:
Dynamic(DHCP)Addressing
(default)
Parameter
Value
Device Mode
Static(Fixed)Addressing
Parameter
Value
Device Mode
IP Address
Enter required value in format:
xxx.xxx.xxx.xxx
Subnet Mask
Default Router
WINS Server
A Virtual CNC must be set up if connection to a supervisor,
tool or display is required.
Use IP Tool – see step 13 – to set up the address and port
number of the vCNC.
Parameter
Range
Address
0 (disabled),
1, 4 to 9, 11 to 119
Port Number
1 to 32767
Defaults to 10000 plus the address
(e.g. address 123 sets port to 10123)
When set to dynamic (DHCP) addressing the unit automatical
obtains its IP addressing details (IP address, subnet mask,
default router, WINS server and DNS server) from the
network’s DHCP (Dynamic Host Configuration Protocol)
server. If no DHCP server is found, the unit defaults to link/
local mode where it autonegotiates its IP address with other
devices on its Ethernet segment,
Note: It is recommended that link/local only be used on a
single segment system.
When set to static (fixed) addresssing the IP addressing
details must be configured manually.
Note: If email alarms are being sent, and the email server
address is identified by internet domain name, then a DNS
server must also be specified using Text Comms.
2
ConFIguRAtIonPRoCeDuRe
(continued)
13
ConnecttoDataCollectorusingSet/IPtool
n
q
4
e
y
e
c
p
4
1
2
3
4
5
Q411B_V53440388
O/S
00:10:70:0D:1E:92
MAC Addr
IQ411-1010U5000
Part No:
LAN
4
IP
Addr
Find the IQ41x by its MAC address shown on
serial label
SET Manual (TE200147)
IP Tool Manual (TE200638)
IP Tool Manual (TE200638)
IP Tool Manual (TE200638)
Draft
