HR/JIG
-8-
100
200
300
400
300
200
100
50mm
90º to
worktop
edge
45º to
worktop
edge
50mm
Ensure jig is lined up at an equal
distance from worktop edge.
Custom design
Custom design
Custom design
Custom design Custom design
ASSEMBLY
Fitting Location Pins
The jig has sets of pin holes to allow the jig to be
accurately positioned at 90˚ or 45˚ to the worktop
edge. The pin holes are at 50mm centres.
Location pins are tapered to ensure a good tight
fit in hole. Insert the smallest end of the pin into
the hole by lightly pushing. Ensure pins are fully
home before use and head is below surface.
When using jig ensure location pins do not foul
workbench.
Marking Out for Hot Rods
The jig has a series of engraved lines on one
side that allow the jig to sighted to lines drawn
on the worktop.
The jig slots allow for certain hot rod lengths to
be routed.
For complicated hot rod slots the jig will need to
be repositioned and the routed slot length limited
by using a user made stop or to a pencil line.
Careful marking out will be required.
Pin
At 90º to Worktop Edge
At 45º to Worktop Edge
