Standard Operating Procedure
Attraction: EUROBUNGY-TRAMPOLINE
August
2011
Policy: Standard Operating Procedures Manual
Approved: Peter Raidt
Page 24 of 39
9.
Tell jumpers:
To wait for direction from the operator before going onto the trampolines
That they must use stairs only to access trampolines
To listen carefully and obey everything the operator is going to tell them
To enjoy the ride
10.
Maintain an awareness of the area and make sure that non-jumpers are never allowed inside
the attraction area.
11.
Keep cashier area clean throughout the day.
12.
DO NOT assist jumpers with getting into harnesses until you are properly trained and
certified as an operator.
OPERATOR
This position must be staffed at all times by a certified EUROBUNGY-TRAMPOLINE operator who
will assist guests into the harnesses, load them onto the attraction, operate the hoist, monitor
the jumper and make necessary adjustments, and finally unload the jumper.
A EUROBUNGY-TRAMPOLINE requires minimum one Operator for two Trampolines !
HARNESSING THE JUMPER
1.
Ask the jumper what their measured weight is and make sure they fall within the weight
restrictions.
2.
Ensure the guest is at the correct jump station for his or her weight class or adjust elastic
combinations as required. If you have to add on or hook off elastics, do that before the
jumpers steps on to the trampoline.
3.
Once the trampoline is cleared of the last jumper, attach the elastics and the harness
according to the weight range table. Pay close attention - the incorrect number of elastics
could lead to a potentially unsafe situation and a to tight harness can cause pain.
4.
The jumper first in line steps onto the trampoline using the access steps only.
5.
When giving instructions to jumpers, use their first name to make them comfortable and to
offer encouragement.
6.
The jumper is to grab the free harness and approach the operator, who is standing in front
of the trampoline.
7.
While fitting the harness to the jumper (and at all other times), always adhere to the
Limited Contact Policy:
Do not tuck guest’s clothing into the harness.
Do not adjust any twists in the harness leg loops.
Do not pull up or down to verify the fit of the harness.
8.
Secure the jumper’s harness
a)
Have the jumper stand in front of the harness.
b)
Place the top strap above the hips of the jumper.
c)
Close the buckle by putting one end into the other end of the buckle (like in a car seat),
