Standard Operating Procedure
Attraction: EUROBUNGY-TRAMPOLINE
August
2011
Policy: Standard Operating Procedures Manual
Approved: Peter Raidt
Page 19 of 39
Check inflatable trampolines for leaks and check it for holes on the trampoline bed/fabric
Check all four anchor points of each EUROBUNGY-TRAMPOLINE structure, ensuring that the
aluminum tubes are properly attached to the small floor plates
Check all four upright tubes on each structure, ensuring that the dolphin mullets are properly
secured by their pins and safety clips
Check all steel cables and turnbuckles to ensure that the are properly tightened and in proper
operating condition
Check all safety pins clips on both the small tubes and the center cross
Check all karabiners for unusual wear. Be sure they open and close properly.
Visual check all the return pulleys, swivel points, ensuring that the pulleys work properly with
no excessive wear, the swivels work properly, and they swivels have their safety pins in
Check the hoist and its rope thoroughly. Check the ropes for excessive wear on the sheath;
check the knots on each connection point, and check the rope connection to the hoist.
Finally check and ensure that the hoist pulls in and lets out the rope properly
Check the setup of the guest harness and hoist system. Each karabiner should be checked
and ensured that it is in the locked position. Check that all spinning pulleys are working
properly. Check the center return pulley that is attached to the hoist rope to ensure that it
works properly and there isn’t any excessive wear.
Check all elastics for wear and tear – replace if necessary
Check bolts and nuts from the platform. Are the bolts which hold the Hoist tight ?
Any condition or observation, which, in your opinion, may affect the safe and efficient operation
of this attraction, must be reported to your supervisor before opening to the public.
