Section 7: Lubrication
4220ST & 4420ST Light Utility Vehicles 700-504M
8/05/08
38
Table of Contents
Oil And Filter Change
Refer to Figure 7-1 on page 37:
See also "Section 10: Specifications and Capacities" on
page 45.
Filler cap location: Top of rear valve cover
Dipstick location: Front left side of engine
Drain plug location: Front bottom center of engine
Type of Lubrication: SAE 10W30
Engine Oil Capacity: 1.5 US qts. with filter replacement,
1.1 US qts. without filter replacement.
Quantity: Fill oil to upper limit mark on dipstick.
Refer to Figure 7-2 and Figure 7-3:
Warm oil drains quickly and completely. Therefore, drain
used engine oil while engine is still warm as follows:
1.
Park vehicle on a level surface, set park brake, turn off
ignition switch and remove switch key.
2.
Place a suitable container below engine to catch used
oil. Remove filter access cover and drain plug to allow
oil to drain out.
3.
Remove oil filter with a filter wrench and let remaining
oil drain out. Discard oil filter.
4.
Clean engine filter base.
5.
Coat new filter O-ring with clean engine oil and install
filter to engine filter base.
6.
Hand tighten oil filter until O-ring seats. Finish
tightening by turning the filter to the specified turning
angle or torque with a torque wrench.
Turning Angle: 7/8 of a turn
Torque: 22 N.m (2.2 kgf.m, 16 lb-ft)
7.
Reinstall and tighten drain plug securely.
8.
Dispose of used motor oil and filter in a manner that is
compatible with the environment. Do not throw used
oil in the trash, pour it on the ground, or down a drain.
9.
Fill engine with 1.5 US quarts of 10W30 oil. Do not
overfill. See "Level Check" on page 37.
10. Replace filler cap, start engine and check oil filter for
leaks.
11. Stop engine and check oil level as outlined in section
titled “Engine Oil Level Check” on page 37.
6 mo/100 hrs
Oil Filter Location
Figure 7-2
Oil Filter O-Ring
Figure 7-3
21134
21134
