Section 4: Operating Instructions
4220ST & 4420ST Light Utility Vehicles 700-504M
8/05/08
16
Table of Contents
Indicating Lights and Gauges
Refer to Figure 4-1:
#1
Hour Meter: Indicates number of hours, to the
nearest 1/10 of an hour, the vehicle has run.
#2
Park Brake Light: Indicates park brake is on when
illuminated. Do not move vehicle with park brake
light on. See note below.
#3
4-Wheel Drive Light: Indicates 4-wheel drive is
activated when illuminated.
#4
Neutral Light: Indicates shift selector is in neutral
when illuminated.
Figure 4-1
#5
Oil Light: Indicates low oil pressure when
illuminated. Stop engine immediately. Check oil
level and add if low. See your authorized Land Pride
dealer if oil light stays on and engine is full of oil. It is
normal for the oil light to come on whenever the
ignition switch is turned on and will stay on until
engine is running.
#6
Volt Meter: Indicates battery is charging. Check
battery if volt meter registers a charge that is lower
than normal. See your authorized Land Pride dealer
if battery is good and volt meter still registers low
charge.
Switches
Refer to Figure 4-2 and Figure 4-3:
#7
Power Plug Outlet: Located on the dash is a power
plug outlet for connecting 12 volt accessories such
as a cell phone or light.
#8
Ignition Switch: Starts and stops engine. Vertical
position is off. Turn switch key clockwise to start
engine. See “General Operation” on page 15 for
correct vehicle starting procedures.
#9
Dump Switch: An electric cylinder raises and
lowers the cargo box. Press top of switch and hold to
raise cargo box. Press bottom of switch and hold to
1
2
6
24696
3
5
4
lower cargo box. Release switch at any position to
stop cargo box. Release switch immediately if
Power Bed Lift Cylinder makes a ratchet noise.
#10
Auxiliary Switch Slot: 12 volt on/off accessory with
switch may be installed at this location.
#11
Light Switch: Turns on head and tail lights. Press
top of switch to turn on lights and bottom of switch to
turn off lights.
#12
4-Wheel Drive Switch: Engages the 4-wheel drive
system. Press top of switch to engage 4-wheel drive
and bottom of switch to disengage 4-wheel drive.
The 4-wheel drive system should be used only
when required to get through a difficult situation.
Figure 4-2
Figure 4-3
IMPORTANT: The Power Bed Lift is protected by an
internal clutch in both directions and will make a loud
“ratchet” noise indicating end of travel has been
reached or Power Bed Lift is overloaded. Release
switch immediately when this noise is heard.
NOTE: 4x4 drive should not be engaged at transport
speed or on hard surface roads.
9
8
10
7
24693
11
12
21460
