Trejon OPTIMAL UPX Series, Инструкция по эксплуатации и техническому обслуживанию, Страница: 30 / 44

Instruction manual TREJON OPTIMAL UPX plough (2010)
30
3.8 Operating the Machine
The TREJON OPTIMAL UPX plough is designed for snow clearing.
NOTE!
DO NOT USE FLOATING MODE ON THE MACHINE’S LOADER OR FRONT LIFT!
NOTE!
DO NOT REVERSE WITH THE PLOUGH DOWN!!
WHEN THE PLOUGH IS RETRACTED, THERE IS NO SAFETY SYSTEM
PROTECTING THE PLOUGH.
1) In some cases, when the plough is placed in the U-position or Z-position (see the image
below), there is a risk of the plough’s wings colliding with the tool carrier’s chassis or
wheels. The operator needs to pay attention and prevent such dangerous situations.
2) As the operator, you are responsible for not travelling at a higher speed than the conditions
allow. Doubling your speed quadruples your kinetic energy in the event of a collision. The
weight of the tool carrier is also a decisive factor, see Technical specifications, Chapter 1.4.
3) Avoid driving into posts, railings, etc.; the plough is equipped with a shock valve that
releases oil from the positive side of the cylinder to the negative side. However, collisions
entail an increased load on the plough.
4)
When the cylinder reaches its “mechanical bottom position”, the collision protection stops
working and there is consequently an increased risk of damage to the plough.
5) Watch out for curbs and traffic islands. When equipped with SHARQ or SHARQ P300,
the
plough is equipped with “pavement steel”, which reduces the risk of injury.
6) Do not press the plough downwards, as this will put strain on and wear the plough
excessively.
Z
U