Trejon OPTIMAL UPX Series, Инструкция по эксплуатации и техническому обслуживанию, Страница: 15 / 44

Instruction manual TREJON OPTIMAL UPX plough (2010)
15
1.10 Cutting blades
The UPX plough is not equipped with a cutting blade as standard (see Figure 13).
The plough must not be used without cutting blades.
Each UPX plough must be configured with suitable cutting blades. It is possible to choose between
different cutting blades: smooth SHARQ (I), perforated SHARQ P300 (II) and wear rubber scraper
blades (III).
Use the accompanying (for each UPX plough) fixation components such as screws (S),
washers (N) and nuts (M) to mount the cutting blades (see Figure 14).
For wear rubber scraper blades (40 mm thickness), longer
screws and a fixing plate are required (see Figure 15).
These are included in the kit
– see options, Chapter 5.
When installing these, the same tightening torque must
be used for all screws. The fixing plate must be pressed
into the rubber scraper blade MAX 2-4 mm.
It is easiest to mount the cutting blades when the plough has been raised from the ground.
This requires that the plough or the loader arm on the tool carrier is steadily raised and
secured.
•
Activate the tool carrier’s parking brake.
•
Raise the plough to the desired height.
•
Support the plough or the loader arm so that the plough cannot drop down.
•
Make sure that the surfaces of the steel holders (D) are clean before installing
the cutting blades, see Figure 14.
•
Personal protective equipment: Helmets, protective goggles, safety shoes
and gloves must be worn during the installation or replacement of the cutting
blades.
Figure 13
A
N
M
D
S
Figure 14
Figure 15
I III
II
NOTE!