Trebs CC-105, Руководство по эксплуатации

Страница: 24 / 32

LED
ANGLE
POWER
POWER PLUG
MONITOR POWER
CABLE
RED
To Fuse Box +12V DC Acc
BLACK
To Chassis Ground
2.4GHz WIRELESS MONITOR
This Schematic is for hard wiring the monitor directly to the vehicle's fuse box.
MONITOR POWER CONNECTION
There are two ways to supply the monitor with power, one uses a 12
Volt cigarette lighter adapter plugged into the vehicle's cigarette lighter
socket, and the other uses a wiring harness hard wired to the vehicle's
box.
12 Volt Cigarette Lighter Adapter Using the Monitor's
ON/OFF Button
1. Plug the end of the power cable into the monitor.
2. Plug the 12 Volt cigarette lighter adapter into the cigarette lighter socket.
3. Press the ON/OFF button to turn the monitor ON and OFF.
Hard Wired to Fuse Box Using the Monitor's ON/OFF
Switch(Fig. 1)
1.Disconnect the negative battery
cable from the vehicle's negative
battery terminal.
2.Connect the Red wire to the 12
Volt +/ACC terminal in the vehicle's
fuse box.See vehicle's owner's
manual for fuse box diagram.
3.The ground cable must be located on an area of metal on the vehicle's
body/firewall that does not have any vehicle components behind it.
Sand off any paint to reveal bare metal, this area will be your chassis
ground.
4.Drill a hole for the supplied self tapping sheet metal screw. Make sure
there are no vehicle components behind where you are drilling the hole.
5.Strip the insulation from the end of the black wire 1.3cm and wrap the
wire around the self-tapping sheet metal screw before tightening.
6.Re-connect the negative battery cable.
7.Plug the power cord into the monitor, use the ON/OFF button to turn
the monitor ON & OFF.
Fig. 1
-6-