Trebs CC-105, Руководство по эксплуатации

Страница: 26 / 32

Camera's
Power Cable
Fig. 5
AND SEE WHAT IS BEHIND WHERE
YOU ARE DRILLING. If there are any
vehicles components, such as electrical
parts or fuel system components behind
where you are drilling, you must take
whatever precaution is necessary not to
damage them. Remove the license plate
and camera before drilling.
7.After you have drilled a hole, insert the
supplied grommet(Fig. 5), then pass the
power cable through the grommet into
the vehicle(Fig. 6). You must use the
grommet to prevent the metal edge of
the hole from cutting the power cable.
Fig. 6
Fig. 7
8.Next you'll need to find the vehicle's
reverse lights. Turn the vehicle's reverse
lights. Turn the vehicle's ignition key to
the accessory position, engage the
parking brake and put the car in reverse.
Look at the vehicle's tail lights to see where the reverse lights are
located, they are the white lights.
To locate the reverse light's 12V+ wire it will be necessary to gain
access to the rear of the vehicle's tail light.
For help locating the vehicle's reverse light circuit contact your vehicle's
manufacturer for vehicle specific wiring diagrams.
9.Once you have located the reverse light circuit you will have to route
the camera's power cable to that location. You must securely fasten the
power cable to prevent it from being caught on any vehicle component
such as the trunk hinge(Fig. 7). Never route the cable on the outside
of the vehicle.
10.The reverse light sockets on most vehicles have two wires connected
to them. Usually the negative wire is black and the positive wire is a
-8-