Transition Networks
CBFTF10xx-1xx User Guide
33403 Rev. E
https://www.transition.com
Page 5 of 15
Hardware/Software Mode Jumper
(J4)
The jumpers are located on the media converter circuit board. Use a small
needlenosed pliers or a similar tool to set the jumper.
The Hardware/Software jumper is labeled “H” for hardware and “S” for
software.
Software: The media converter mode is determined by the most-recently
saved on-board settings.
Hardware: The media converter mode is determined by the 6-position switch settings listed above.
Install the Slide-in-Module
To install the CBFTF10xx-105 media converter slide-in module:
1. Locate an empty installation slot on the
PointSystem™
chassis.
2. Carefully slide the module into the installation slot, aligning the module with the installation guides.
3. Ensure that the module is firmly seated inside the chassis.
4. Push in and rotate the panel fastener screw to secure the module to the chassis front.
