Disabling or Enabling Units
This section is for users who wish to disable some of the available weight units displayable on the EL-
3000.
When first purchased, the EL-3000 comes with all available displayable units enabled. The units appear
in the following sequence with each press of the
MODE
key:
LB
kg
g
oz
%
Pcs
Unit Wt.
NOTE:
If the Pieces mode is disabled, the Unit Wt. Mode will automatically be disabled.
To enable or disable displayable units:
1. Turn the scale off. You will find the ON/OFF switch on the bottom of the scale, near the back.
2. While holding down the
MODE
key, turn the scale back on. Continue holding down the
MODE
key
until the scale shows the “LB” unit with either the “ON” message or the “OFF” message.
The “ON” and “OFF” messages designate the unit’s status, either enabled or disabled.
3. To change a unit’s status, press the
SAMPLE
key. Each press of the
SAMPLE
key will toggle the
shown unit between “ON” and “OFF”.
4. To change to the next unit, press the
MODE
key.
5. Repeat steps 3 and 4 until all units have been programmed as desired.
6. Once the desired units have been enabled or disabled, save the configuration by pressing the
ZERO/CLEAR
key to resume normal operation.
6
Revision 2.95
