15
21
Prepare the bridge for enrollment.
Î
Î
Note: If the bridge is already installed with a lock, follow the instructions as
they are written in the following steps. If the bridge is not installed, follow the
Quick Start Guide publication number P516-288 shipped with the thermostat
starter kit.
a. Unplug Ethernet and power cables from bridge.
b. Verify that blue light is blinking. If blue light is solid, battery is dead.
c. Install a quality 9 volt battery.
d. Take bridge to the location where the thermostat is mounted.
Blue
light
Battery
Enroll Thermostat into Schlage LiNK™ System
22
Enroll the thermostat into the bridge. (Inclusion)
If you are using a controller that is not a Schlage LiNKTM bridge, consult the
Quick Start Guide that came with the controller to find out how to enroll a new
device.
a. Hold the bridge within 6 feet (1.8 meters) of the thermostat throughout steps
“b” through “f”.
Î
Î
After you begin the enrollment process, you have 30 seconds to complete
the remainder of the steps. Study the steps below before beginning.
b. Press and release the plus (+) button on the bridge.
c. Press the MENU button on the thermostat.
d. Scroll down to Z Wave Install, and press the Select button.
e. Press the Yes button to enroll the thermostat.
f.
Observe the lights on the bridge. The orange light will blink while enrollment
is taking place. Enrollment is complete when the orange light becomes solid.
MENU
button
MENU MODE FAN RUN
75
76 H
74 C
11:15 AM
Done
Select
Menu Selection
User Settings
Usage Graph
ESM Setpoints
ZWave Install
Select
button
Scroll
down
Gat
ew
ay
MENU MODE
F
AN R
UN
75
76 H
74 C
11:15 AM Ou
tside 60
“+” Button
23
Verify enrollment of the thermostat.
a. Scroll down to
Thermostat Info
, and press the
Select
button.
b. Look at the number listed after
ZNID
.
• If the number listed there is anything other than “000”, the thermostat
has been successfully enrolled.
• If the number listed there is “000”, the thermostat has NOT been
successfully enrolled. In this case, repeat step 22 and verify again.
c. Press Done button 2 times when finished.
ZNID
Done
Thermostat Info
TZEMT500AB32 Ver: 01.00.13
ZVER:02.00.0 ZNID: 013
ZHID: 01.07.37.a7
System Type: Standard
Fan Type: Gas
