69-1592–1
3
MULTISTAGE ELECTRONIC THERMOSTAT
Pub. No. 18-HD28D1-1
Fig. 3. Typical hookup of TAYSTAT 375 in a multistage
heating and cooling system.
Fig. 4. Correct wiring technique.
Mounting Thermostat
1. Engage tabs at the top of the thermostat and
wallplate. See Fig. 5.
2. Press lower edge of case to close and latch.
Using Thermostat Keys
Use thermostat keys to:
•
Set temperature,
•
Display present setting,
•
Configure installer setup,
•
Check system test,
•
Display outdoor temperature.
•
Set system operation,
•
Set fan operation.
See Fig. 6 for key information.
M4826
FOR WRAPAROUND
INSERTION STRIP
7/16 IN. (11 MM).
FOR STRAIGHT
INSERTION STRIP
5/16 IN. (8 MM).
Fig. 5. Mounting thermostat on wallplate.
NOTE: To remove the thermostat from the wall, first pull
out at the bottom of the thermostat; then remove
the top.
M6801
DISPLAY PRESENT
SETTINGS AND SCROLL
THROUGH INSTALLER
SETUP MODES
(INFORMATION KEY)
i
DECREASE
TEMPERATURE
SETTING
INCREASE
TEMPERATURE
SETTING
Fig. 6. Thermostat key locations and descriptions.
SETTINGS
System and Fan Settings
System settings control the thermostat operation as
follows:
Heat: The thermostat controls the heating.
Off: Both the heating and cooling are off.
Cool: The thermostat controls the cooling.
Auto: The thermostat automatically changes between
heating and cooling operation, depending on the
indoor temperature.
Fan settings control the system fan as follows:
On: Fan operates continuously.
Auto: Equipment controls fan.
The system default setting is Heat and the fan default
setting is Auto. Use the keyboard or system and fan
switches to change to the desired settings. See Fig. 7.
M14278
B.
PRESS LOWER EDGE OF CASE TO LATCH.
A.
ENGAGE TABS AT TOP OF THERMOSTAT AND WALLPLATE.
W2
L1
(HOT)
L2
M20272
FAN
RELAY
Y1
G
B
THERMOSTAT
HEAT
RELAY
1
R
W1
COMPRESSOR
CONTACTOR 1
Y2
COMPRESSOR
CONTACTOR 2
TRANSFORMER
HEAT
RELAY
2
OT
OT
OUTDOOR
SENSOR
1
POWER SUPPLY. PROVIDE DISCONNECT MEANS
AND OVERLOAD PROTECTION AS REQUIRED.
1
Содержание TAYSTAT 375
Страница 11: ......
