Trane SENS-IN-1D18-HD60D29-4, Руководство по установке

Страница: 3 / 20

3
General Information
Kit Inspection
Upon receipt of the kit, immediately note;
[ ] Any visible damage to the exterior shipping package.
Record any damage on the shipping documents.
Specify the type and extent of the damage on the “bill of
lading” before signing.
[ ] Unpack the contents and carefully inspect it for obvious
damage due to shipment.
[ ] If concealed damage has occurred, notify the carrier’s
terminal of the damage immediately by phone and by
mail. Concealed damage must be reported within 15
days.
[ ] Do not remove damaged material from the receiving lo-
cation. Take photos of the damage, if possible. The
owner must provide reasonable evidence that the dam-
age did not occur after delivery.
[ ] Check for material shortages. Within the package you
should find;
1 - Sensor Module,
1 – Package of mounting hardware, and;
1 - Installation and operation manual.
Contact the Parts Center nearest your area should there be
any damaged or missing components.
Remote Panel w/ NSB - BAYSENS019B
This 7 day programmable sensor features 2,3 or 4 periods
for Occupied or Unoccupied programming per day. If the
power is interrupted, the program is retained in permanent
memory. If power is off for an extended period of time, only
the clock and day may have to be reset.
The Zone Sensor allows selection of four system modes
(Heat, Cool, Auto, and Off), two fan modes (On and Auto). It
has dual temperature selection with programmable start
time capability.
The occupied cooling set point ranges between 45 and 98
degrees Fahrenheit.The heating set point ranges between
43 and 96 degrees Fahrenheit.
A liquid crystal display (LCD) displays zone temperature,
temperature set points, day of the week, time, and opera-
tional mode symbols.
The Option Menu is used to enable or disable applicable
functions, i.e.; Morning Warm-up, Economizer minimum po-
sition override during unoccupied status, Fahrenheit or
Centigrade, Supply air tempering, Remote zone tempera-
ture sensor, 12/24 hour time display, Smart fan, and Com-
puted recovery.
During an occupied period, an auxiliary relay rated for 1.25
amps @ 30 volts AC with one set of single pole double
throw contacts is activated.