7
General Information
Warranty
Warranty is based on the general terms and conditions of Trane.The warranty is void if the equipment is
repaired or modified without the written approval of the manufacturer, if the operating limits are exceeded or if
the control system or the electrical wiring is modified. Damage due to misuse, lack of maintenance or failure
to comply with the manufacturer’s instructions or recommendations is not covered by the warranty obligation.
If the user does not conform to the rules of this manual, it may entail cancellation of warranty and liabilities by
the manufacturer.
Unit Description
RTXC XE high efficiency range includes 10 unit sizes 110, 160, 180, 200, 220, 310, 330, 360, 400 and
440XE with partial heat recovery (PHR) option. The 220XE and as below are independent units with single
water-side heat exchanger, the 310XE and as above are installed by the customer on site.
The 310XE, 330XE, 360XE, 400XE and 440XE are formed by a combination of two units as followed :
Unit Name
310XE 330XE 360XE 400XE 440XE
Unit 1 (Master)
200XE 220XE 200XE 200XE 220XE
Unit 2 (Slave)
110XE 110XE 160XE 200XE 220XE
The unit features twin-rotor screw compressor, high-efficiency fin-tube air-side heat exchanger, TRANE
patented falling film water-side heat exchanger, BPHE economizer, optional hot water side BPHE for partial
heat recovery function and TRANE exclusive UC800 control. The 220XE and as below have already
completed all the assembly and test work before shipment to ensure each unit providing chilled /heated water
efficiently and reliably. The 310XE model and as above will be installed by the customer on-site for parallel
connection of water pipes,as well as the electric control wiring and setting, refer to "
" part of this manual.
Reception
To protect against loss due to damage incurred in transit, complete the following checklist upon receipt of the
unit.
•
When the unit is delivered, verify that it is the correct unit and that it is properly equipped. Compare the
information which appears on the unit nameplate with the ordering and submittal information. Check if the
model number of unit nameplate consistent with the order. Refer to “
•
Inspect all exterior components for visible damage. Report any apparent damage or material shortage to the
carrier and make a “unit damage” notation on the carrier's delivery receipt. Specify the extent and type of
damage found and notify the appropriate Trane Sales Office.
•
Inspect the unit for concealed damage as soon as possible after delivery and before it is stored. Concealed
damage must be reported within 15 days.
o
If concealed damage is discovered, stop unpacking the shipment. Do not remove damaged material from the
receiving location. Take photos of the damage, if possible. The owner must provide reasonable evidence that
the damage did not occur after delivery.
o
Notify the carrier's terminal of the damage immediately, by phone and by mail. Request an immediate, joint
inspection of the damage with the carrier and the consignee. Notify the Trane sales representative and
arrange for repair. Do not repair the unit, however, until damage is inspected by the carrier's representative.
Do not proceed with installation of a damaged unit without TRANE sales office approval.
•
Check all the accessories and loose parts which are shipped with the unit against the original order. Included
in these items will be water vessel drain plugs, rigging diagrams, electrical diagrams, and service literature,