5 Connecting the camera
The Everec ME1 is supplied with a matching camera and microphone.
Figure 5: Camera with microphone
Connect the camera cable to the 12-pin Hirose connector (HR10A-12Pin) on top of the Everec
ME1 by inserting the connector slightly and turning it a little, until the contacts are in place; in
doing so, the arrow on the connector casing sits above the operating buttons. The cable is now
secure even if it is pulled.
To remove it, slide the outer housing of the plug upward, and pull out the plug.
The top side of the camera is marked with a dot.
Additional to camera and microphone there is a switch to start and stop recording at the cable. A
LED in the switch lights up as soon as the Everec ME1 is turned on and indicates that the recor-
der is ready to record. It is blinking while recording.
Note
: Do not turn the plug while pulling it.
© July 2008
Page 10/33
Instruction Manual
