Wiring Loom Fitting Instructions
To Suit
Mazda CX-8
Part Number
102066-WL
Cequent Customer Service
Ph
:
1800 812 017 Fax
:
03 9898 3299
:
info@cequent
.
com
.
au
Post
:
PO Box 4050, Dandenong South VIC 3175
Rev
:
A Page 3 Issue Date
:
14-02-2019
22. On the LHS,using an alcohol wipe, clean the LHS inner sheet metal area and the
underside of the ECU (04826).
23. Connect the trailer patch 12-way connector to the ECU.
24. Apply double sided tape to the ECU and secure it to the vehicle sheet metal.
No
te: Mount the ECU, ensuring the connector is orientated downwards.
25. Remove the LHS front and rear passenger scuff trim.
26. Route both the orange power wire and RPA disable patch down the LHS of the
vehicle towards the LHS kick panel.
Note: To avoid entire removal of trim, utilise a guide wire.
27. In the passenger seat area, remove the kick panel trim by releasing the nut on the
firewall.
28. Remove the glove box by disconnecting the damping rod and then squeezing both
sides to release.
29. Insert the supplied 20 Amp Fuse into the Add-A-Fuse and then insert the Add-A-Fuse
into the blank fuse location in the orientation shown.
30. Connect the Add-A-Fuse to the mating connector on the power wire.
Note: To maintain correct electrical operation, ensure you insert the fuse
adaptor into the allocated slot and in the orientation shown.
31. Route the Reverse Park Assist disable patch connectors up towards the Parking
Assist Module above the glove box.
32. Disconnect the connector from the ECU and patch in the mating T patch connectors
into the vehicle ECU and the vehicle harness.
33. With the rear bumper removed, below the LHS tail lamp, locate the 30mm blanking
grommet cover and remove.
34. Secure tail harness (Part number: WLT025) to tow bar.
35. Route tail harness up through chassis rail and previously removed vehicle blanking
grommet.
36. Seat grommet in 30mm blanking hole and route to trailer harness blue connector on
wiring loom.
Note: Keep harness routing clear of all sharp edges, moving parts and places
of extreme heat.
Note: Ensure grommet is seated correctly and makes a good seal.
37. Connect the tail harness 8-way connector to the trailer patch mating 8-way connector.
