Wiring Loom Fitting Instructions
To Suit
Mazda CX-8
Part Number
102066-WL
Cequent Customer Service
Ph
:
1800 812 017 Fax
:
03 9898 3299
:
info@cequent
.
com
.
au
Post
:
PO Box 4050, Dandenong South VIC 3175
Rev
:
A Page 2 Issue Date
:
14-02-2019
1. In the engine bay, disconnect the negative battery.
2. In the boot, fold down the third row seats.
3. Remove the centre storage tray cover.
4. Remove the LHS and RHS storage tray covers.
5. Remove the spare wheel cover.
6. Remove the LHS and RHS tool tray.
7. On the rear scuff plate (1), use a plastic trim removal tool to pop out the centre of the
two clips and remove from scuff plate.
8. Remove the rear scuff plate by pulling in an upwards direction.
9. Remove the vehicle jack.
10. Remove the last tool tray.
11. On the LHS, remove the trim clip under the previously removed scuff plate.
Repeat for RHS.
12. Remove
the 10mm bolt behind the ‘D’ pillar luggage securing hood cover.
Repeat for RHS.
13. Pop the centre cover off the luggage securing clip near the rear ventilation vent.
Repeat for RHS.
14. Remove 10mm bolt behind the cover.
Repeat for RHS.
15. Fold LHS trim in towards the centre of the vehicle.
16. Remove the LHS sound deadening carpet enough to gain access to the tail lamp
connectors.
17. Patch in the LHS mating connectors on the trailer patch (102066-WL) to the mating
LHS tail light connectors on the vehicle.
18. Connect the ground wire ring terminal to the vehicle earthing point.
19. Route the T section of the harness along the existing vehicle loom towards the RHS.
20. Fold RHS trim in towards the centre of the vehicle and remove the sound deadening
carpet covering the tail lamp connectors.
21. Patch in the RHS mating connectors on the trailer Patch to the mating RHS tail light
connectors on the vehicle.
