TracVision A5, Руководство по установке, Страница: 47 / 78

54-0208-01
3.9
Installing the Receiver
Connecting the Audio/Video Cables
The TracVision A5 kitpack includes standard
audio/video (A/V) cables with RCA-type connectors
for connecting the receiver to the vehicle’s
entertainment system. However, the receiver’s rear
panel also offers an S-video jack and an RF coaxial
video jack, if needed. Follow the procedure below for
your particular installation. If you need to connect a
VCR to the vehicle’s entertainment system, see the
alternate wiring instructions in the next section,
“Connecting a VCR.”
Option 1 - RCA-type A/V Jacks (very good picture
quality)
Option 2 - S-Video Jack (best picture quality)
Option 3 - RF Coaxial Connector (good picture
quality)
Option 1 - RCA-type A/V Jacks
(very good picture quality)
If the vehicle’s entertainment system has standard
RCA-type A/V jacks, follow the steps below.
1. Connect the supplied audio/video cables to the
lower “Audio R,” “Audio L,” and “Video” jacks
on the receiver’s rear panel.
2. Connect the other ends of the audio/video cables
to the
entertainment system ’s audio and video
inputs. If the system has only one audio input jack,
connect the audio cable that is connected to the
receiver’s “Audio L” jack.
C AU T I O N
AUDIO R AUDIO L VIDEO
S – VIDEO
OUT TO TV
TUNER
Receiver
To Vehicle
Audio
To Vehicle Video
(Option 1, RCA) To Vehicle Video
(Option
To Vehicle Video
(Option 3, Coax)
To Vehicle Video
(Option 2, S-Video)
POWER
VEHICLE POWER
(10-16 VDC)
VHF ANTENNA
IN
PHONE JACK
RF
REMOTE
INPUT
SATELLITE IN
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device must not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Tested to comply
with FCC Standards
TO SATELLITE
IN
TO KVH
ANTENNA
DIAGNOSTICS
PORT 1
DIAGNOSTICS
PORT 2