TracVision A5, Руководство по установке

Страница: 4 / 78

1
TracVision A5 Installation Guide – ADDENDUM
54-0208-01 Addendum to Rev. E
TracVision A5 Installation
Guide Addendum
ECO #7253
The following information applies to Revision E of the
TracVision A5 Installation Guide (KVH Part Number 54-0208-01).
This addendum concerns the rack mount kit only. It does not
apply to the roof mount kit.
Kitpack Contents - Rack Mount Kit Only
The retaining blocks have been replaced by new steel retaining
plates, which make the antenna much easier to install. Therefore,
the rack mount kit contents listed on page 1.7 have been replaced
by the following parts:
Part Part # Qty.
Retaining plates 02-1441 4
1 ⁄
4
"-20 x 1 3 ⁄
4
" TORX screws 14-0414-28 4
1 ⁄
4
"-20 x 2" TORX screws 14-0414-32 4
1 ⁄
4
"-20 jam nuts 14-0415 8
Rubber cushions 24-0173 8
Mounting the Antenna - Rack Mount Kit
Steps 5 through 7 on pages 2.8 and 2.9 have been replaced by the
step below.
5. Using a 1 ⁄
4
" driver and the supplied
T27 TORX bit, secure each mounting
bracket to the roof rack with a
retaining plate, two flat-head TORX
screws, and two jam nuts, as shown
in the figure. Use a 1
3 ⁄
4
" TORX screw
at the end of each bracket and use a
2" TORX screw at the base of each
bracket. After securing all four
brackets to the crossbars, verify that
all cushions
(two within each bracket)
are pressed firmly against the
crossbars providing a solid grip.
Flat-head
TORX Screws
Cover
Roof Rack Crossbar
Retaining Plate
Jam Nuts
Mounting Bracket
2"
1.75"
Note: This figure shows the optional second spacer.