TracVision A5, Руководство по установке, Страница: 20 / 78

2-1 Attaching the Mounting Brackets
The antenna has either an exposed cable connector
(Version A) or a recessed connector (Version B).
Follow the instructions for the antenna version you
are installing to attach a supplied mounting bracket
underneath each of the antenna’s four corners. Use a
1 ⁄
4
" driver and the supplied T27 TORX bit to tighten
the screws.
54-0208-01
Installing the Antenna
Version A
Version B
Exposed
Connector
Bracket
Factory-installed bolt
1/4"-20 TORX screws
(with Nylok patch) x 2
Use three 1 ⁄
4
"-20 x 1" TORX screws and one 1 ⁄
4
" flat
washer (in the center) to attach each mounting
bracket to the antenna base.
Bracket
1/4"-20 TORX screw
(with Nylok patch)
and 1/4" flat washer
1/4"-20 TORX screws
(with Nylok patch) x 2
Recessed
Connector
IMPORTANT!
The center screw and washer are critical
for a safe installation!
If the kitpack is
missing any hardware, please call KVH
Technical Support at 401-847-3327. The
screws are treated with a thread-locking
Nylok patch; do not use any substitutes.
Use two
1
⁄
4
"-20 x 1" TORX screws to attach each
mounting bracket to the antenna base. (A bolt is
factory-installed in the base between the bracket holes.)
TORX Screw Head
2.3