Operators Manual - Pentruder Modular Drilling system
31
Important!
Do not start the power pack when oil level is low, and
never with the oil filter cap removed.
Start the power pack and let it run for approximately 10 seconds and
shut it off again. Control the oil level and top up if necessary . On the
76 mm level indicator the oil should be up to 1/3 of the glass when the
power pack is switched off, with the new 127 mm level indicator the
oil should be up to 2/3 of the glass when the power pack is switched
off.
Oil filter:
The new filters can be ordered from your dealer on Part.
No. 60 13 01 00.
Oil change in the power
p. gear transmission:
To change oil, put the power pack on the back, unscrew the oil-plug
and drain the housing completely. Refill with 0.3 L of GL5
specification gearbox oil, preferably synthetic oil with 75W/90
viscosity. Clean the magnetic plug, fit it and tighten firmly again.
GEARBOX
Oil change in
Gearbox MD41:
The Pentruder drill system has a separate 4-speed gearbox, which is
lubricated in a separate oil bath. To change oil, unscrew the oil-plug
and drain completely. Refill with 0.4 L of
GL5 specification
gearbox oil,
preferably synthetic oil with 75W/90 viscosity. Clean the magnetic
plug, fit it and tighten firmly again.
SPINDLE UNIT
Oil change in the
Spindle unit
The Pentruder drill system has a separate output gearbox or spindle
unit, which is lubricated in a separate oil bath. To change oil, unscrew
the oil-plug and drain completely. Refill with 0.2 L of
GL5 specification
gearbox oil, preferably synthetic oil with 75W/90 viscosity. Clean the
magnetic plug, fit it and tighten firmly again.
Cleaning:
The machine should be carefully cleaned and all functions checked
and be found normal before use of the machine.
Hoses:
Check that all hoses are the correct type, R2 for the main ¾” hoses,
and that they are in faultless condition.
Quick disconnect
hydraulic couplings:
Check all couplings for proper function and replace when necessary.
