6
A
B
2xd
d
3.
INSTALLATION
3.1.
SCAFOR™ hoist installation
Fix the hoist by inserting the top part into the frame
guide pin and moving it from top to bottom in relation to
frame (A), (Fiig.3)
Then fix the lower part of the hoist to the frame using
twi bolts (screw + Nyloc bolt) supplied with the SCA-
FOR™ hoist (B).
3.2. Insert the lifting wire rope
This operation requires two operators, one near the
seat and the second on the roof.
The operator working at a height
must wear a safety harness and
be attached to a sufficiently strong
anchor point.
Risk of injury!
Wear safety gloves!
Only use wire rope recommended
by the manufacturer.
Refer to the user manual for
SCAFOR™ hoist.
Ensure that
the diameter of the lifting wire rope (9) correspond
•
to the diameter shown on the SCAFOR
TM
hoist
technical plate,
the length of wire rope is sufficient for the applica-
•
tion and
the end of the wire rope is as set out in fig. 4.
•
Avoid making loops when unreeling
the wire rope (Fig. 5).
Set the seat vertically under the suspension point.
1.
Pull the lifting wire rope (hook side) on to the roof
2.
using a cord.
Fasten the hook to the suspension anchor point.
3.
Fasten the upper safety hook (10) of the BLOC-
4.
FOR™ fall arrest device to the second anchor
point of the suspension.
Fasten a cord (A) to the lower safety hook (11) of
5.
the BLOCFOR™ fall arrest device.
Refer to the user manual for the suspension
for fixing the wire rope and the BLOCFOR
TM
fall arrest
device to the suspension point.
Danger
Main components
SCAFOR™ hoist installation
Fig. 3 -
Wire rope
Fig. 4 -
end
Unwind the wire rope
Fig. 5 -
- MC1452-SUBITO_6FR-EN-D-IT-ES-NL 0
7
/201
8
