TrackSAT UltraTrack TS61, Инструкция по установке и эксплуатации

Страница: 13 / 36

9
①
Connect the DC “power adapter cable” to the power connector from the power source 100
~ 240 V AC.
② Connect the RF cable threaded from RF4 port on the ADU to the “Antenna port” on the
ACU panel.
③ Connect the RF cable from the “receiver port” on the ACU to the RF connector (SAT IN or
LNB IN port) on the VAST or Foxtel Box. Use Sat 69 for VAST 70 for Foxtel.
④ (Optional) Connect the ship gyro cable from the ship gyro to the NMEA connector on the
ACU. (see Section – 2.8 for more detailed gyro connection)
NOTE: For Single IRD configuration refer to Section 3.3.4 – a for ACU setting
2.7.2 Multi IRD Configuration
This configuration can be used with or
without a multi-switch. But a multi-
switch may need to be used if you have
multiple Foxtel or VAST set top boxes.
An additional RF cable connection
required for multiple IRD’s
①
Connect the DC “power adapter
cable” to the power connector from
the power source 100 ~ 240 V AC.
② Connect the RF cable threaded
from the RF4 port on the ADU to
the “Antenna port” on the ACU
panel. Then connect to The ACU to
a multi-switch H input or the Foxtel
box (or VAST set top box if no
Foxtel boxes are used).
③ Connect the RF cable threaded
from the RF1 or RF3 port to the V
input port on the multi-switch or if
no multi-switch connect to the
VAST set top box if there is a Foxtel
box connected to RF4 port.
Figure 14 –Multi IRD Configuration