Tracker LS2 2020, Руководство по ремонту и обслуживанию

Страница: 92 / 164

B
74
Repair and Service Manual
ENGINE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
699322
NOTICE: If vehicle is to be stored over winter
months, it can be stored with old oil left in engine.
The oil should be changed as part of spring mainte-
nance. This will remove any moisture that has accu-
mulated during storage.
Be aware that engine fluids may be
hot and contact to the skin may
cause severe burns. Wear rubber
gloves to protect skin from exposure to the old oil
and degreaser.
The oil should be changed with engine warm. Park vehicle on a
level surface, engage parking brake and remove key. Place a
drain pan under engine. Wipe top of the engine clean with a cloth
(Ref. Fig. 4). Remove the oil fill cap.
Fig. 4 Cleaning Top of Engine
Be careful of hot oil when drained. It
may be hot enough to burn you.
Place the oil drain pan under the oil drain plug (1) found at
the rear of the engine base. Remove the drain plug (1),
allow the oil to drain into the drain pan.
Fig. 5 Oil Drain Plug
Before installing the drain plug clean the area around the
drain plug mount with a lint free cloth and inspect the
drain plug (1) for damage; replace if necessary (Ref. Fig.
5). If the ’O’ ring (2) on the drain plug is damaged replace
it with a new one and tighten to the specified torque.
At the first oil change, small metal chips and lint may be
found. This is normal, resulting from the break-in period.
Inspect the filter at every oil change. The presence of
large metal chips could indicate possible damage to the
engine.
Fig. 6 Remove Oil Filter
Clean the area around filter. Place the oil drain pan under
the filter area. Using a filter wrench, strap wrench or other
suitable filter wrench (3), remove the filter (4) from the
engine and allow the oil to drain into the oil drain pan
(Ref. Fig. 6). The ‘O’ ring (5) may remain on engine (6) or
filter (7) (Ref. Fig. 7).
Inspect the filter to make sure the ‘O’ ring is not left on the
engine surface (6), if the ’O’ ring has remained on the
engine surface remove it and discard with the filter.
Fig. 7 Inspect Oil Filter
Inspect the new oil filter for any defects, apply engine oil
to the ’O’ ring seal and install the new oil filter onto the
engine until the seal contacts mounting surface of the
engine. Then turn the filter 2/3 to 3/4 rotation by hand.
Pour in the specified type and amount of oil.
Oil capacity is 1.4 quarts (1.3 liters). Add slightly less than
1.4 quarts (1.3 liters) to allow for possible residual oil left
in engine. The oil must be high quality oil that meets or
exceeds API SF, SG, CC standards (Ref. Fig. 3). Check
oil level on dipstick. Oil should be slightly below ‘H’ to
allow for expansion. If necessary, continue to add oil
slowly and allow time for oil to flow down into engine.
Check oil level on dipstick. Do NOT overfill.
ITEM TORQUE SPECIFICATION
1 61 in. lbs (7 Nm)
Oil Fill Cap
1
2
1
3
5
6
7
6
5
7