Tracker LS2 2020, Руководство по ремонту и обслуживанию

Страница: 19 / 164

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
1
Repair and Service Manual
699322
GENERAL INFORMATION AND ROUTINE MAINTENANCE
SERIAL NUMBER PLATE
Two serial number and manufacture date code labels are
on the vehicle. One is on the body below the front, driver
side of the seat. The other two are located on the chassis
under the seat. The serial number is also engraved on
the flat portion of the frame rail.
Fig. 1 Serial Number Plate & Location
Design changes take place on an ongoing basis. In order
to obtain correct components for the vehicle, the manu-
facture date code, serial number and vehicle model must
be provided when ordering service parts.
STARTING THE VEHICLE WITH A
DISCHARGED BATTERY
Do not attempt to ‘jump start’ a
vehicle using another vehicle.
The vehicle is equipped with a starter/generator. When
starting the engine, the starter/generator functions as a
starter and with the engine running, it functions as a gen-
erator.
With the short running times associated with this kind of
vehicle, the generator is more than adequate to maintain
the battery charge level. The generator is not designed to
charge a discharged battery.
Since the engine stops when the accelerator is released,
jump starting should not be attempted .
If the vehicle is equipped with lights and/or accessories
that are used when the vehicle is not in motion, the
starter/generator may not be adequate to maintain bat-
tery charge. In this situation, the battery may require
charging with a 12V 10 amp max charger.
Observe all instructions provided by the manufacturer of
the charger.
SERVICING THE VEHICLE
To prevent severe injury or death,
resulting from improper servicing
techniques, observe the following
Warnings:
Do not attempt any type of servicing oper-
ations before reading and understanding
all notice, cautions and warnings in this
manual.
Any servicing requiring
adjustments to be made
to the powertrain while
the motor is running must
be made with both drive
wheels raised.
Wear eye protection when working on the
vehicle. In particular, use care when work-
ing around batteries, or using solvents or
compressed air.
To reduce the possibility of causing an
electrical arc, which could result in a bat-
tery explosion, turn off all electrical loads
from the batteries before removing any
heavy gauge battery wires.
To prevent the possibility of motor disinte-
gration, never operate vehicle at full throt-
tle for more than 4 - 5 seconds while
vehicle is in a “no load” condition.
It is in the best interest of both vehicle owner and servic-
ing dealer, to carefully follow the procedures recom-
mended in this manual. Adequate preventative
maintenance, applied at regular intervals, is the best
guarantee for keeping the vehicle both dependable and
economical.
In any product, components will eventually fail to perform
properly as the result of normal use, age, wear or abuse.
It is virtually impossible to anticipate all possible compo-
nent failures or the manner in which each component
may fail.
A vehicle requiring repair indicates the vehicle is no lon-
ger functioning as designed and should be considered
potentially hazardous. Use extreme care when working
on a vehicle. When diagnosing, removing or replacing
any components that are not operating properly, consider
the safety of yourself and those around you, should the
component move unexpectedly.
Some components are heavy, spring loaded, highly cor-
rosive, explosive, may produce amperage or reach high
temperatures. Gasoline, carbon monoxide, battery acid
and hydrogen gas could result in serious bodily injury to
the technician/mechanic and bystanders, if not treated
with the utmost caution. Be careful not to place hands,
face, feet or body in a location that could expose them to
Serial Number
Labels