Tracker LS2 2020, Руководство по ремонту и обслуживанию

Страница: 138 / 164

B
120
Repair and Service Manual
ELECTRICAL
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
699322
battery voltage indicates that the power wire is in good
condition.
NOTICE: The power wire supplies power to the
entire fuse block.
4. Check fuse
Place the red probe (+) to each wire terminal on the
fuse block. A reading of battery voltage indicates that
the fuse is in good condition. No reading indicates a
faulty fuse; replace with a good 15 amp fuse.
ACCESSORY WIRING
After determining that there is power to the fuse panel,
and the fuse is good, continue checking the circuit using
the procedures previously used to check the power sup-
ply, i.e. loose or rusted connections, bare wires, continuity
of the wiring from terminal to terminal, operating condition
of switch, etc.
Use the wiring diagram (Ref. ) to check correct wiring and
wire routing. If there is power at the fuse end of the wire,
there must also be power at the other end of the wire at
the switch or electrical accessory, and eventually at the
ground connection. Electricity must flow from the fuse
panel through the full length of the circuit to the ground
connection. Any interruption of electrical flow must be
corrected, whether by repairing or replacing the wire, the
switch or accessory