Metalyser
®
Portable HM1000
Instruction Manual v 5.0
Driver Installation
Your Metalyser
®
is compatible with most computers with a USB socket, but first the USB
drivers may need to be installed. The drivers are located on the Software USB stick
provided for all versions of Windows post Windows 95.
Insert the USB memory stick into an available USB port on your PC
Connect the USB cable supplied to the Metalyser
®
instrument as described for
battery charging. Connect the other end to an available USB port on your PC
Windows will run the
‘install new hardware wizard’
When asked if Windows can connect to Windows update to search for software.
Select
‘No, not this time’
Select
‘Install from a list or specific location’, navigate to USB memory drive
Windows should install the drivers
Once complete, the wizard will run again. Use the same settings as before
Once Windows has installed the drivers, reboot the computer and your Metalyser
®
should be installed
To verify correct installation select fast charge on the instrument and check that
the fast charge icon (see page 7) is displayed on the Metalyser
®
’s screen
Setting the Date and Time
The Metalyser
®
contains a calendar and clock which is used to date stamp the results log.
The clock may be set to UTC when you receive the instrument so may need re-setting. It
will also need re-setting if the battery is disconnected. To set the clock follow these steps.
From the main menu, select
System
From the system menu, select
Set date/time
and press
<OK>
Use the navigation key to alter the date and time
Press
<OK>
when finished to save settings
