TL-WPA4220
300Mbps AV500 WiFi Powerline Extender
4
2.3 Physical Interface
There are four physical items on this device.
Item
Description
Wi-Fi/Wi-Fi
Clone Button
Press the button for 2 seconds to start Wi-Fi Clone.
Press the button for 5 seconds to enable or disable the wireless function.
Ethernet Port Two 10/100Mbps Ethernet port connected to PC LAN card or broadband device.
Reset Button Press the button more than 5 seconds, the device will restore to its factory
defaults.
Pair Button
Pair buttons are used to secure a powerline network.
Note:
1. If you press the Pair button for more than 10 seconds, the extender will leave the network it is
associated with and its network name assumes a random value.
2. For detailed information about the Reset button and Pair button, please refer to
Chapter 5 Pair
Button and Reset Button
.
2.4 Hardware Connection
Please first make sure that your PC can successfully access the Internet via the router. Then connect
the powerline devices by following the instructions below.
Step 1: Connecting to the Internet
This section describes how to connect the powerline extender into your existing network. Follow the
procedures described below:
1
.
Connect one end of an Ethernet (RJ45) cable to the Ethernet port of the powerline extender or a
compatible powerline adapter like TL-PA4020P.
Wi-Fi/Wi-Fi Clone Button
Ethernet Port
Pair Button
Reset Button