![background image](http://html.mh-extra.com/html/tp-link/safestream-tl-r600vpn/safestream-tl-r600vpn_configuration-manual_1144817136.webp)
Configuration Guide
128
Configuring VPN
IPSec VPN Configuration
When the
LAN-to-LAN
mode is selected, the following section will appear.
Remote
Gateway
Enter an IP address or a domain name (1 to 255 characters) as the remote
gateway. 0.0.0.0 represents any IP address. Only when the negotiation mode is
set to Responder Mode can you enter 0.0.0.0.
WAN
Specify the WAN port on which the IPSec tunnel is established.
Local Subnet
Specify the local network. (It’s always the IP address range of LAN on the local
side of the VPN tunnel.) It’s formed from the IP address and subnet mask.
Remote Subnet
Specify the remote network. (It’s always the IP address range of LAN on the
remote peer of the VPN tunnel.) It’s formed from the IP address and subnet mask.
Pre-shared Key
Specify the unique pre-shared key for both peers’ authentication.
Status
Choose to enable the IPSec policy.
When the
Client-to-LAN
mode is selected, the following section will appear.
Remote Host
Enter the IP address of the remote host. 0.0.0.0 represents any IP address.
WAN
Specify the WAN port on which the IPSec tunnel is established.
Local Subnet
Specify the local network. (This is the IP address range of the LAN on the local
side of the VPN tunnel.) It’s formed from the IP address and subnet mask.
Pre-shared Key
Specify the unique pre-shared key for both peers’ authentication.
Status
Choose to enable the IPSec policy.
3) Click
OK
.
2.1.2 Configuring the Advanced Parameters
Advanced settings include IKEv1 phase-1 settings and IKEv1 phase-2 settings. IKEv1
phase-1 is used to authenticate both sides of the communication and establish the IKE