Town & Country Fireplaces TCWS.54CE2, Инструкция по установке и эксплуатации

Страница: 23 / 40

1. Remove the 2 inner screws from the upper heat shield. (Fig. #35)
2. Slip the top porcelain panel into the lip at the front of the fi rebox and tip
the panel up to align with the screw holes. Secure with the previously removed
screws. (Fig. #36)
3. Insert the back panel into the fi rebox by tilting the panel and rest the panel
on the seat tabs at the back of the fi rebox. (Fig. #37)
NOTE: Seat tabs can be lowered if the rear panel is tight.
NOTE: Centering tabs on the panel should be located at the outside of the
seat tabs.
4. While supporting the back panel insert the left side panel into the fi rebox.
Position the top of the panel against the side of the unit, inserting the top panel
tab into the slot at the top of the side panel and slide the bottom into position.
(Fig. #38)
NOTE: Notch at bottom of side panel faces to front of unit.
5. Repeat step 4 for the other side panel.
NOTE: Install burner now.
6. Place the front panel on the front lip of the fi rebox, wide fl ange facing the
front. (Fig. #39)(Proceed to step #7 if you are installing a TCWS.54NG03.C2
Black Diamond burner with this unit.)
7.
Place the other front panel piece at the rear of the fi rebox with the
wide fl ange facing to the rear against the back panel.
Fig. #35
Fig. #36
Fig. #38
Fig. #37
Fig. #39
SEAT TABS
23
TCWS.54CE2 200810-40
Firebox Panels Installation