The lower rear panel is held tight against the
side panels by two "V" brackets located on
the fi rebox rear wall. Although the brackets
are adjusted at the factory for the best fi t,
some adjustment may be necessary. Adjust
the angle of the bracket by hand to ensure
a snug fi t.
A Firebox Panel Set must be installed for safe operation. Do not use the fi replace without
panels. Unpack and inspect all panels. The panels need to be installed before the logs are
in place.
Caution:
The Firebox Panels are very fragile, and should be handled with care.
1. Remove the Side Panel Retainer located on the underside of the fi rebox heat shield.
The retainer slips between the lip of the fi rebox and the heat shield and is retained in
place by two screws (Fig. 46 & Fig. 47).
2. Install the Lower Rear Panel.
(See Porcelain panel instruction manual for specifi c instructions for these panels) Before
proceeding see burner instructions.
SIDE PANEL RETAINER
HEAT SHIELD
FIREBOX LIP
Fig. #46
SCREWS
Fig. #47
REAR LOWER PANEL
ADJUSTABLE “V” BRACKET
28
TC36.CODE 102513-40
Firebox Panels Installation
Fig. #45
Содержание TC36.OD
Страница 34: ...Fig 50 Wiring Diagram 34 TC36 CODE 102513 40 ...
Страница 35: ...35 TC36 COD 102513 40 ...
