Adjustable Lintel
Fig. #20
Fig. #21
Fig. #22
1. The adjustable lintel assembly has two
orientations for desired fi nishing. A fl anged
edge and a hemmed edge. The lintel comes
factory installed with the fl ange edge out. If
the desired edge is different from the factory
setting, use the following steps to change
it(Fig.#20).
2. Remove the window trim by lifting and
pulling to disengage from the window frame
(Fig.#21).
3. Loosen the securing bolts in the upper and
lower corners on each side of the lintel
and remove the lintel. Rotate the assembly
to have the desired edge away from the
fi replace(Fig .#22).
4. The lintel assembly has a maximum range
of adjustability of 1” to accommodate varying
facing material thicknesses. The maximum
depth is 6” (Fig.#24).
5. The lintel assembly can then be adjusted
to align fl ush with your facing material by
sliding in or out approximately 1”.
6. Tighten the securing bolts. (Fig.#22).
7.
Re-attach the window trim.
HEMMED EDGE
FLANGED EDGE
TRIM
SECURING
BOLT
14
TC36.CODE 102513-40
Содержание TC36.OD
Страница 34: ...Fig 50 Wiring Diagram 34 TC36 CODE 102513 40 ...
Страница 35: ...35 TC36 COD 102513 40 ...
