Tower Hobbies KAOSARF .60/EP, Инструкция по эксплуатации

Страница: 5 / 24

5
PREPARATION
❏
1. Use a covering iron set to about 300°F with a covering
sock to go over the model where necessary to shrink the
covering and remove any wrinkles and to bond the covering
to wood underneath. If you will be using a glow engine, pay
special attention to the edges of the covering around the
firewall to make sure it is thoroughly sealed down so fuel
won’t get in.
NOTE: This covering material requires less heat than
you may be used to – too much heat may cause seams
and edges to draw away from each other causing wavy,
uneven edges or exposed balsa.
❏
2. If powering your Kaos with a glow engine, apply a film
of epoxy or CA to seams around the firewall.
❏
3. Give a generous tug on all control surfaces to check the
hinges. Add thin CA where necessary to any loose hinges.
Residual CA or any CA “fog” can be removed with a paper
towel dampened with CA debonder.
ASSEMBLE THE WING
❏
1. Attach a 6" [150mm] servo extension to each
aileron servo and secure with the included 1-1/2" [40mm]
shrink tubing.