- 18 -
tousek
/ EN_ST-80-M-S_05 / 25. 03. 2020
Note: The factory settings of the single menu
points are marked with
in this manual.
The mechanical stops have to be placed so
that possibly existing safety contact edges
can not be triggered, as this would lead to
an error message.
Diagnosis
Connections and adjustments
Status display
M/S
Reset / Diagnosis
Status display on text display
for inputs like photocell, contact edge, stop switch, impulse switch ....
I
impulse button
P
partial opening
C
CLOSE-button
S
STOP-button
Ph
photocell contact
ME
contact edge at main safety edge
1
induction loop 1
2
induction loop 2
Delete positions
M
Reset / Diagnosis
NO:
does not delete the end positions “closed” and “open”
YES:
the determined end positions are beeing deleted.
Note: the end positions will be determined after new impulse
Factory setting
M
Reset / Diagnosis
NO:
Kno reset back to factory settings
YES:
reset back to factory settings and delete the
adjusted limits.The end posistions (limits) will be
redetermined after impulse
(in Master- and
Slave-control).
the limit positions are newly set after an impulse.
Software version
(control function)
M/S
Reset / Diagnosis
shows the software version on display
Serial number
(control function)
M/S
Reset / Diagnosis
shows the serial number on text display
Protocole
M/S
Reset / Diagnosis
shows the protocole list on display:
all events that take place are protocolled in this list.
with the buttons
+
and
-
the single events can be seen:
Status Sensor
(control function)
M/S
Reset / Diagnosis
Degree and signal strength of rotation speed sensor is shown on display.
All inputs okay.
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
T -00 00:00:00.0
Event
With
*
the protocole beginning
hence the end is shown
type of event
Time since the last event:
DAYS HOURS : MINUTES : SECONDS
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
I P C S Ph ME 12
$$$$$$$$$$$$$$$$
$$$$$$$$$$$$$$$$
I P C S Ph ME 12
e.g.
If for any reason one of the two control boards is being exchanged without the other, then first of
all, the command „delete positions“ in the menu „diagnosis“ has to be executed otherwise it may
cause a fatal system crash!
Impulse-, pedestrian - and close button not triggered.
STOP-button and photocell are triggered.
Contact strip (main closing edge) not connected or defect.
induction loop 1, 2 not triggered.
$
Status: not triggered
$
-
Status:
triggered
$
x
Status: contact strip not connected or defect
$
o
Status: contact strip or photocell deactivated in menu
Содержание ST 80
Страница 27: ......
