1) Receiver Output Voltages
A) The receiver has four output voltage (channels) which will operate four separate circuits. The
output voltage is 12 volts direct current (vdc). The maximum drive current for each of the four
output channels is 300mA (maximum). The four outputs can (drive) turn On small bulbs or
relay coils.
B) Check the power requirement for the bulb before connecting to the receiver. 12vdc at 0.1amp
(maximum) or 1 watt (maximum)
C) Check the power requirement for the relay before connecting to the receiver. The relay coil
should be rated for the current requirements. The maximum allowable coil current is 300mA.
2) Determine where the receiver and antenna will be located.
Typically the RF receiver is located under the dash or behind a wall panel in the back. If the receiver
is to be mounted outside the cab area then you must protect the receiver. The receiver is NOT
waterproof or moisture resistant*.
DO NOT
mount the receiver and antenna:
A) Within 6 feet of a motor
B) Near large bundles of wires
C) Near other antennas or RF devices
D) The antenna should not be touching any metal as this grounds the RF (radio
frequency)
signal
*TouchTronics offers weather resistant housings for many different types of applications. Call the
factory @ 1-800-294-2570 for information on your particular application needs.
Page -4-
Installation: Planning
PowerTouch Remote Control Systems - 814 Series (2 - 4) Functions
Manual C814.N2
Installation: Receiver Power & Ground
WARNING!
Use ONLY a volt meter to check voltage
during installation and testing.
*Using a test light WILL damage the outputs!
(
-
)
Battery
(
+
)
#10 x 3/4” Screw
#10 3/16” Star Washer
#10 3/16” Ring Terminal
Vehicle Frame
Scrape paint and clean area before installing ground screw.
A loose chassis ground connection WILL cause intermittent operation!
Chassis Ground
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Red
Violet
Pink
Green/Black
Yellow/Black
Brown
Blue
Black
(+) Input +12v Battery Power
(+) Output Channel 1 - Button ‘A’
(+) Output Channel 2 - Button ‘B’
(-) Output Channel 1 - Button ‘A’
(-) Output Channel 2 - Button ‘B’
(-) Output Channel 3 - Buttons ‘A’ & ‘B’
(-) Output Channel 4 - Back Button
(-) Input Ground - Connect to Chassis
Ground using External Tooth Washer
PowerTouch Remote Control System
Series 814 RF Receiver
This device complies with FCC rules part 15.
Operation is subject to the following 2 conditions:
1) This device may not cause harmful interference
2) This device must accept any interference received
including that causing undesired operation
36” Gray Antenna Wire
*Maximum output current 300mA.
Over current will damage outputs.
Fused 1a Maximum
