Page -8-
Use a digital or analog voltmeter to check power and voltage!
Do NOT use a test light
Trouble Shooting Guide - 814 Series Remote Control
PowerTouch Remote Control Systems - 814 Series (2 - 4) Functions
Manual C814.N2
1.0
No output from one
or more channels on
remote control receiver
1.1
No signal from
transmitter
1.2
One or both of the
outputs have failed.
1.3
Receiver outputs ok,
but relays or equipment
do not operate.
1.1
Verify that transmitter is sending a signal and
that transmitter is coded correctly. See symptom
3.00
1.2a
Press each transmitter button in sequence.
While pressing button,
use only a voltmeter probe
to check each corresponding output
(Green/black = button ‘A’)
(Yellow/black = button ‘B’).
1.2b
If checking voltage, a ground signal is
present when button is pressed and float when not
pressed.
1.2c
If checking ohms, the outputs should read 9-
ohms when button is pressed and 0- ohms when
not pressed.
1.2d
If outputs read nothing when pressed or not
pressed, then the power supply is damaged.
1.2e
Send back to factory for repair or
replacement.
1.2f
Any of the above problems can be caused by
a defective unit or damage by the customer from
over-voltage, over-current or testing the inputs
and outputs using a test light instead of a
voltmeter.
1.3
Check wire and equipment for problem
Symptom
Trouble Shooting Guide - 814 Series Remote Control
Possible Cause
Corrective Action
2.0
Signal transmitted
and received, but no
operation.
2.1
No signal from
transmitter
2.2
One or both of the
outputs have failed
2.3
Receiver has failed
outputs
2.1
Check wire harness for loose connections or
damaged wires or terminals
2.2
Check equipment for problem in motors or
relays
2.3
Recheck section 1.0
Symptom
Possible Cause
Corrective Action
